Illinois SOS CDL General Knowledge Practice Test 12

  • Questions30
  • Correct to pass24
  • Passing score80%
  • Minimum age18 years

Minimum age: 18 years for an intrastate CLP or CDL; 21 years for interstate operation or to transport passengers

30 questions. Pick an answer to see if it is right and why; you need 24 correct answers to pass.

  1. 1. What does the federal bridge formula do?

    Show answer

    Answer C: It reduces the weight allowed on a group of axles as those axles get closer together

    Axles bunched together concentrate the load on a short span of a bridge, so the formula lowers the allowable weight as the spacing shrinks.

  2. 2. Which exhaust system condition must be reported as a defect?

    Show answer

    Answer B: A section repaired by wrapping tape or patching material around the pipe

    Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.

  3. 3. Part of your load stands high enough to hide a rear lamp or a reflector. What must be done?

    Show answer

    Answer B: The load must be moved or extra lamps fitted so the required lights can be seen

    Required lamps and reflectors must remain visible; if the cargo blocks them, the load is rearranged or additional lamps are fitted so the vehicle can still be seen.

  4. 4. How do you avoid the sharp lurch that comes at the very end of a stop in a heavy vehicle?

    Show answer

    Answer A: Ease off the brake pressure just before the vehicle actually comes to rest

    A smooth stop is finished by reducing pedal pressure as the vehicle settles, so the suspension does not rock the cab and the load forward.

  5. 5. How should a driver use brakes fitted with an antilock system during an emergency stop?

    Show answer

    Answer C: Brake as usual and keep enough pressure to stay in control while steering around the hazard

    The system only works when the brakes are applied hard enough for it to act, so the driver keeps pressure on and steers while the system prevents lockup.

  6. 6. What should be checked about the power steering system in the engine compartment?

    Show answer

    Answer D: That the fluid level is correct and the hoses and pump are not leaking

    Losing power steering fluid means losing steering assistance, which can happen suddenly and makes a heavy vehicle very hard to turn.

  7. 7. How can a driver restart the 60 or 70 hour on-duty limit?

    Show answer

    Answer B: Take 34 or more consecutive hours off duty

    A period of 34 or more consecutive hours off duty resets the 60 or 70 hour calculation so the driver can begin a new period.

  8. 8. Which CDL endorsement exists only on an Illinois commercial driver's license?

    Show answer

    Answer D: The C charter bus endorsement

    Illinois lists the C charter bus endorsement as an Illinois CDL only endorsement, while T, N and S are standard endorsements used nationwide.

  9. 9. After starting a trip, when must a driver first re-inspect the cargo and the devices holding it?

    Show answer

    Answer A: Within the first 50 miles

    Federal rules require a check of the load and its securement within the first 50 miles, because settling and vibration loosen straps and chains early in a trip.

  10. 10. Under federal rules, what happens to a commercial driver found with any detectable amount of alcohol while operating a commercial vehicle?

    Show answer

    Answer D: The driver is placed out of service for 24 hours

    Any measurable alcohol takes a commercial driver off the road for 24 hours, and a concentration of 0.04 percent or more brings a disqualification.

  11. 11. Which situations call for a mirror check in a commercial vehicle?

    Show answer

    Answer A: Every lane change, turn, merge and tight maneuver

    Mirrors must be checked regularly and always before, during and after any movement that changes the path of the vehicle.

  12. 12. A strap runs from an anchor point on one side of the trailer, over the load, and down to an anchor point on the opposite side. How much of its working load limit counts toward the total required?

    Show answer

    Answer C: All of it

    A tiedown that is anchored on one side, passes over or around the cargo and is anchored on the other side counts its full working load limit toward the aggregate figure.

  13. 13. During uncoupling, when may the fifth wheel locking lever be released?

    Show answer

    Answer D: Only after the landing gear is down and taking the weight of the trailer

    The landing gear has to be supporting the trailer before the lock is released; otherwise the trailer nose can drop as soon as the tractor pulls out.

  14. 14. Two vehicles of exactly the same length make a right turn, one gently and one very tightly. What is the effect on off-tracking?

    Show answer

    Answer A: Turning more sharply increases off-tracking, so the tight turn needs more room

    Off-tracking depends on both the length of the vehicle and the sharpness of the turn; a tighter corner brings the rear wheels further inside the path of the front wheels.

  15. 15. Besides staying secure, cargo carried inside a vehicle must not do what?

    Show answer

    Answer C: Block the driver view or access to emergency equipment and exits

    Cargo may not obstruct the view to the front or sides or prevent the driver from reaching emergency equipment and exits.

  16. 16. Experienced commercial drivers scan the road ahead by roughly how much travel time?

    Show answer

    Answer B: About 12 to 15 seconds

    Looking 12 to 15 seconds ahead gives a heavy vehicle enough room to slow or change lanes smoothly instead of reacting late.

  17. 17. At a stop on a hot day you find a tire that is too hot to touch. What should you do?

    Show answer

    Answer C: Wait until the tire cools before driving on, and do not let air out of it

    A tire that is too hot to touch may be about to fail or catch fire; releasing air only leaves it underinflated once it cools, which makes things worse.

  18. 18. During the walkaround inspection, where does the driver normally start and how does the check proceed?

    Show answer

    Answer C: At the left front of the vehicle, working around it in a set order that returns to the cab

    The walkaround follows the same route every time, starting at the left front and circling the vehicle, so that nothing is skipped when the driver is tired or rushed.

  19. 19. A commercial driver is convicted of two serious traffic violations within three years. What is the result?

    Show answer

    Answer D: Disqualification for 60 days

    Two serious traffic violations in a three year period bring a 60 day disqualification, and a third in the same period raises it to 120 days.

  20. 20. Which brake lining condition must be reported?

    Show answer

    Answer C: Linings that are worn thin, loose, cracked or soaked with oil or grease

    Linings must have enough material left and must be securely attached and clean, because a thin, loose or contaminated lining cannot deliver its share of braking.

  21. 21. Below 40 mph, what following distance does the standard commercial rule of thumb call for?

    Show answer

    Answer C: One second for every 10 feet of vehicle length

    The base rule allows one second of space for each 10 feet of vehicle length while speed stays under 40 mph.

  22. 22. Why should you never shift gears while crossing railroad tracks?

    Show answer

    Answer A: You could miss the gear or stall and be stuck on the tracks

    A stalled or coasting vehicle on the tracks has no way to clear quickly, so choose the gear before the crossing and do not shift until you are across.

  23. 23. What is the purpose of the torque rods or radius rods you check on the suspension?

    Show answer

    Answer A: They hold the axle in alignment with the frame under braking and acceleration

    Torque rods resist the twisting and fore and aft forces on the axle, so a cracked or missing rod lets the axle move out of alignment.

  24. 24. Which steering system findings count as defects during the inspection?

    Show answer

    Answer C: Bent, loose or broken column parts, arms, drag links or tie rods, and missing nuts, bolts or cotter keys

    Every joint and fastener between the steering wheel and the tires carries the driver commands, so looseness or a missing retainer can end in a complete loss of steering.

  25. 25. How often must every commercial motor vehicle receive a periodic inspection?

    Show answer

    Answer C: At least once every twelve months

    Federal rules require each commercial motor vehicle to pass a periodic inspection at least once in every twelve month period.

  26. 26. How many questions are on the Illinois Air Brakes and Combination knowledge tests?

    Show answer

    Answer B: 25 on Air Brakes and 20 on Combination

    Illinois lists the Air Brakes test at 25 questions and the Combination test at 20 questions, the same length used for the Passenger, Tank, School Bus and Doubles endorsements.

  27. 27. How do you test for leaks in a hydraulic brake system during the pre-trip inspection?

    Show answer

    Answer A: Pump the pedal three times, then hold firm pressure for five seconds and make sure the pedal does not move

    If the pedal sinks while you hold pressure, fluid is escaping or air is in the lines, and the vehicle must not be driven until the problem is repaired.

  28. 28. Your axle weights are legal, but the tires on that axle are rated below the weight it is carrying. What controls?

    Show answer

    Answer B: The lower figure, so the tires may not be loaded beyond their marked rating

    You may never exceed the rating marked on a tire, even when the axle limit would allow more, because an overloaded tire builds heat and can fail.

  29. 29. Besides the hours when the law requires them, when should headlights be switched on?

    Show answer

    Answer A: Any time visibility is poor, such as in rain, fog or at dusk

    Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.

  30. 30. What is wrong with resting your foot on the clutch pedal between shifts?

    Show answer

    Answer B: It slowly wears the clutch out, because the pressure plate is never fully engaged

    Any weight on the pedal partly disengages the clutch, so it slips and wears; the foot belongs off the pedal once the shift is finished.