Illinois SOS CDL General Knowledge Practice Test 8
- Questions30
- Correct to pass24
- Passing score80%
- Minimum age18 years
-
1. When should the horn of a commercial vehicle be used?
Show answer
Answer C: Only when it is needed to avoid a crash
An air horn is loud enough to startle other road users, so it is a warning device rather than a way to comment on other drivers.
-
2. Why is a leaking exhaust system on a commercial vehicle dangerous to the driver?
Show answer
Answer B: It can let carbon monoxide reach the cab, where it can poison the occupants
Exhaust gas contains carbon monoxide, which has no smell and dulls the driver judgment long before it becomes obvious that anything is wrong.
-
3. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
4. When turning left, what should a driver of a long vehicle do before beginning the turn?
Show answer
Answer B: Reach the center of the intersection so the rear wheels clear the corner
The rear wheels follow a tighter path than the front, so the vehicle must reach the center of the intersection before the turn begins.
-
5. In very hot weather, how often should you check the tires during a trip?
Show answer
Answer D: About every two hours or every 100 miles
Heat raises tire pressure and can lead to blowouts, so tires are checked about every two hours or 100 miles when it is very hot.
-
6. Using the snub braking method on a downgrade, when does the driver release the brakes?
Show answer
Answer A: After speed has dropped about 5 mph below the safe speed
The driver brakes firmly to about 5 mph under the chosen safe speed, releases to let the brakes cool, then repeats when the safe speed returns.
-
7. An empty van trailer cleared a low overpass on the way in, but on the way back it is loaded. Which statement is true?
Show answer
Answer C: An empty van rides higher than a loaded one, so it needs more clearance than when loaded
Springs compress under load, so an empty trailer is taller; the unloaded trip is the one that can catch a low overhead.
-
8. What is the risk when too little weight rests on the drive axles?
Show answer
Answer A: Poor traction, so the drive wheels spin easily on wet or slippery surfaces
Traction depends on weight pressing the driving tires onto the road, so a light drive axle spins on wet, snowy or loose surfaces.
-
9. How many questions does the Illinois general CDL core knowledge test contain, and what score is needed?
Show answer
Answer D: 30 questions with a minimum score of 80 percent
The Illinois CDL Study Guide states the general core knowledge test consists of 30 standardized multiple-choice questions and requires a minimum score of 80 percent.
-
10. What must be checked on a sliding fifth wheel during the inspection?
Show answer
Answer B: That it is locked in position and not so far forward that the trailer can hit the cab
A slider that is unlocked can move under braking, and one set too far forward lets the trailer strike the cab when the tractor turns sharply.
-
11. At a rest area you find that the load has shifted although the straps still feel tight. What should you do?
Show answer
Answer C: Correct the load before driving on, since a shifted load is no longer secure
Movement means the securement has already failed once, and a load that has shifted can shift again, so it is put right before the vehicle moves.
-
12. A dock crew loads and straps the freight. Who is responsible for the load being legal and secure on the road?
Show answer
Answer D: The driver
Even when someone else loads and secures the freight, the driver must inspect it and remains responsible for it while driving.
-
13. How does bracing differ from blocking when securing cargo?
Show answer
Answer B: Bracing runs from the upper part of the cargo to the floor or walls to keep it from moving, while blocking fits snugly against the cargo
Blocking is shaped to fit against the front, back or sides of a piece of cargo; bracing supports it from above so it cannot tip or shift.
-
14. How do you confirm that the coupling is locked before pulling out of the yard?
Show answer
Answer D: By locking the trailer brakes and pulling gently forward against them
The tug test loads the coupling in the direction that would pull it apart, so if the jaws are not closed on the kingpin you find out at walking pace.
-
15. A hard frost has left your vehicle covered in ice. What must be cleared before you drive?
Show answer
Answer D: The windshield, mirrors, lights and reflectors
You must be able to see out and other drivers must be able to see your lights and reflectors, so all of those surfaces have to be cleared.
-
16. What is the correct way to make a right turn in a long vehicle?
Show answer
Answer D: Keep the rear of the vehicle close to the curb and swing wide only as you complete the turn
Swinging left before a right turn invites another driver to move into the gap on your right, so any extra width is taken as the turn is finished.
-
17. A fire starts in the cargo area of a van trailer. Why should you keep the doors closed until firefighters arrive?
Show answer
Answer D: Opening the doors lets in air that feeds the fire
A fire in a closed van is starved of oxygen; opening the doors gives it the air it needs to flare up.
-
18. How is free play in the steering wheel measured during the inspection?
Show answer
Answer B: By turning the wheel until the front wheels just start to move and noting the movement
Play is the movement at the rim that produces no movement at the road wheels, so it is measured by turning until the wheels first respond.
-
19. If an intersection has two lanes marked for left turns, which one should a large vehicle use?
Show answer
Answer D: The right hand of the two turning lanes
The outside turning lane leaves room for the rear of the vehicle to swing without striking a vehicle in the adjacent lane.
-
20. What should a driver assume about the height posted at a bridge or an overpass?
Show answer
Answer B: That it may be wrong, because repaving or packed snow can leave less clearance than the sign shows
Resurfacing and packed snow raise the road under the structure, so the real clearance can be lower than the posted figure.
-
21. What is checked in step six of the seven-step method?
Show answer
Answer D: The turn signals and the stop lights, checked from outside the vehicle
Step six returns to the cab to switch on the signal and stop lamps, then checks each one from outside, because those lamps are not lit during the earlier light check.
-
22. Which items belong to the trailer part of the walkaround inspection?
Show answer
Answer D: Landing gear, doors, tires, wheels, lights, reflectors, frame and cargo securement
The trailer has its own running gear, lighting, structure and load, and all of it is the responsibility of the driver pulling it.
-
23. How does a typical escape ramp stop a runaway vehicle?
Show answer
Answer B: With a bed of loose gravel or sand, often on an upgrade
Escape ramps use deep loose material, usually combined with a rising grade, so the vehicle is slowed gradually instead of being stopped by impact.
-
24. You want to check whether a tire on your truck is properly inflated. What is the correct method?
Show answer
Answer A: Measure the pressure with a tire gauge
Only a tire gauge tells you the actual pressure; a tire can look and sound normal while being badly underinflated.
-
25. Why is driving much slower than the rest of the traffic dangerous?
Show answer
Answer B: Other drivers must keep passing you, which creates conflicts
Traffic that has to work its way around you produces lane changes and closing speeds, which is why a large speed difference is itself a hazard.
-
26. Which of these is a suspension defect you must look for during the walkaround?
Show answer
Answer D: Cracked or broken spring leaves, loose or broken U-bolts, or leaking air suspension bags
Broken springs, failed U-bolts and leaking air bags let the axle shift or the body drop, which can make the vehicle impossible to control.
-
27. Which set of maneuvers makes up the basic control skills part of the commercial driving test?
Show answer
Answer D: Straight line backing, offset backing, parallel parking and alley docking
The basic control skills test is carried out off the road and consists of low speed exercises such as straight line backing, offset backing, parallel parking and the alley dock.
-
28. You are hauling an open box of loose gravel. What does that load require?
Show answer
Answer A: A cover, so that material cannot blow off or spill onto the road
Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.
-
29. Why should water never be used on an electrical fire or a gasoline fire?
Show answer
Answer C: It spreads the fuel and conducts the current
Water carries current back to the person holding the hose and floats burning fuel outward, which is why a B:C rated extinguisher is carried instead.
-
30. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.